This page defines some default parameters for the profile cut-out tool.
Make Ready Settings - Profile Chamfer
Normal Chamfer Profile
External - from the pulldown list choose the palette for the external matrix profile.
Internal - from the pulldown list choose the palette for any internal matrix profiles.
Profile Chamfer Tool - these values will be used to calculate the profile tool width as shown in the final view with tool paths only.
Base tool diameter - this is the diameter of the tool at the tip.
Chamfer tool angle - this is the angle of the tool, as shown in the diagram below.
Override chamfer width - switch this option on if you want to manually override the chamfer width calculated from the diameter and angle.
Effective chamfer width - having selected the above option you can enter the override value here.
Automatic Cut Line Relief
Keep away distance from cut - distance to offset any cut entities that clash with the external profile ensuring the external matrix profile doesn't clash with any cutting rules.
Crease end clearance - this allows the matrix profile to extend beyond the crease ends allowing for profile tool width reducing any crease ends.
Width - allowance parallel to the crease.
End distance - offset applied to end of the crease.