Will change the default rubber offset from any entities that are enclosed within a rubber block profile, e.g. loose pieces of glue perforation rule on a flap, fully enclosed with rubber.
The Edit Bar controls will display the following options when the tool starts:
Rubber Edit - The current tool.
Offset - Set the offset value to be applied to all internal entities.
Pick line for palette - If this option is enabled, only entities of a specified palette will be affected.
To use: Set Edit Bar options and pick a rubber block to change with the mouse. The Offset will be applied to all internal fully enclosed entities unless the Pick line for palette option is enabled. In the latter case a second click on an entity of the required palette inside the rubber block is required and the offset will then be applied to entities of that palette only.