This form is called when you edit a Rule Preparation Block.
End Allowance
Mode
From the drop-down list choose the required mode; None, Reduce or Extend.
Offset
Enter the required reduction or extension value.
Get
If this button is pressed you should select the entity that this end of the block intersects with. Half the rule width of the identified entity will be copied into the Offset entry field and the entity's rule height will be copied into the Rule onto height entry field.
Adjust
Enter the adjustment value that will be added to the reduction/extension offset value.
Mitre
Select this option if a mitre is to be added to this end of the block.
Mitre side
From the drop-down list choose the required side; Left, Right or Both sides.
Lip or Deduction
Select the required radio button, from None, Deduction, Lip or Reversed Lip.