Open navigation

Slots

This page is used to determine how slots in the drawing are identified and treated.

Automatic Rubber Setup - Slots

Choose the appropriate radio button.

  • None - if slots are not to be given any special treatment
  • Hard rubber- if blocks smaller than a given area are to be automatically created using the hard rubber palette.
    • Palette - From the pulldown list choose the required hard rubber palette.
    • Area - Enter the maximum area for blocks to be given this palette.
  • Slot- if slots are to be recognised automatically.
    • Palette - From the pulldown list choose the required palette.
    • Rubber to knife distance - Enter the distance to offset from the original geometry.
    • Slot width - Enter the maximum width that a slot can be.
    • Minimum area - Enter the minimum area that a slot can be.
    • Maximum area - Enter the maximuum area that a slot can be.
    • Automatic detection - Switch this option on if slots are to be detected automatically.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.

You may like to read -