Separators are used to ensure the rubber blocks are inserted at the correct offset from the rule.
Automatic Rubber Setup - Separators
Shape
Select the style of separator required.
Add fillets to smooth separators
This option determines if the intersection of the fillets to the rubber profile is trimmed with a radius or to a point.
Override width
If this option is not checked the width will be the same as the depth.
Separator width
Override the width of the separator by entering a value here.
Automatic placement
This option will add separators to all rubber blocks where the geometry allows.
Spacing
Enter the approximate distance between separators on a single entity. The separators will be placed in a 1-2-1 style on each entity.
Minimum line length
Separators will be added to any entity where the length is greater than the minimum value.
Apply separators to
You can specify which rubber areas should have separators automatically added. The check-boxes will only be enabled if that particular area is enabled.
Sheet Rubber
- Border
- Internal Areas
- Waste Areas
- Rotary
- One-up Interior
- Perimeter
- Waste Areas
- Slots