The Stripper Male Component Library Settings form can be opened from Master Tool Settings or the Stripper Creator tool.
These settings represent all the values required by the Stripper Creator tool that relate to a collection of Male stripping components, usually of the same type but different sizes, that may be interchanged and substituted for each other depending on the particular job.
Male Stripper Component Library
Name
Enter the unique MTS name.
Description
Enter an optional description for these settings.
Male Stripper Components
Add
This will open the Male Stripper Component form to select a new Male Component to add.
Change
This will open the Male Stripper Component form to change the settings of the highlighted Male Component.
Delete
This will remove the highlighted Male Component from the list.
Alternative Symbols
Defined for all
If all the Male Components defined in the library have consistently named, common alternative symbols defined within them, then they will be listed here. If you wish to use the Alternative Symbol tool, then the library must have such alternatives defined.
Incomplete
If some of the Male Components defined in the library have alternative symbols defined within them, but not with a consistent name across all the components, then they will be listed here, so that any inconsistencies may be rectified. If you wish to use the Alternative Symbol tool, then the library must have consistent alternatives defined.