Automatic Rubber Setup - Profile Rubber
Profile rubber palette
From the pulldown list select the palette for the profile rubber.
NOTE: The Palette Attributes of the profile rubber define the width of the rubber created. The Manufacturing - Width determines the width created. The Bevel Distance defines the lip distance created.
Cutback at cut line intersection
Enter the distance that the profile rubber will stop short of a cut type entity.
Cutback at crease line intersection
Enter the distance that the profile rubber will stop short of a crease type entity.
Minimum end angle
Enter the minimum internal angle of the profile rubber. If the resulting angle is greater than specified, the profile rubber length will be reduced to create the minimum angle.
Minimum length
Enter a value here to prevent profile rubber being added to short entities.
Profile only along nicks
Switch this option on to mask the profile rubber around nicks.
Nick distance
Enter the offset distance around each nick.
Add profile to external
Automatic profile rubber is normally only added to internal common knifes and the first knife. Switch this option on to add profile rubber to the back edge and sides as well.
Add profile to first knife
Switch this option off if you don't want the profile rubber adding to the first knife.
Split and keep overlapped rubber
Switch this option on split any underneath rubber. Otherwise it will be masked out.
Override palette types
By default the palette types that are used for profile rubber are Cut, Strip Knife and Balancing Knife. Switch this option on and choose from the list of palette types if you want to override this default.