Machine Attributes - MultiCAM Settings
The MultiCAM Driver Settings page can only be configured if the MultiCAM driver is selected from the General page of the plotter machine.
Output in 3D mode
Select this option to output 3D data to the MultiCAM driver. This is based on the normal HPGL data format, but using a third (Z) coordinate to specify the depth of the tool.
Plunge feed-rate (%)
This is a percentage applied to the actual feedrate when the tool is driven into the material.
Tool’s low position
This is the height of the tool before it is driven into the material.
Tool’s move position
This is the height of the tool for moving.