This is a sub-page from the Stripper System - General page.
Stripper System - General - Bridges
Inside width
Enter the default value for the width of the bridge on an Inside stripper.
Outside width
Enter the default value for the width of the bridge on an Outside stripper.
Inside minimum no.
Enter the minimum number of bridges you must add to each Inside stripping area/region before it is completed and you can exit the tool without a warning.
Outside minimum no.
Enter the minimum number of bridges you must add to each Outside stripping area/region before it is completed and you can exit the tool without a warning.
Bridge to palette
If this option is checked, the profiles for the male, female, front edge upper and lower will be bridged according to the palette attributes.