Waste Planner - General
Stripped areas
Select those types of waste that should be stripped. All others will be marked as retained.
- Sides
- Back edge
- Skeleton
- Internal of carton
- Internal of sheet
Editing
Allow manual editing
Switch this option on to enable the interactive function of the tool.
Ordering
Mode
Choose from the following options if you want to specify the order that the waste areas are labelled:
- None
- Chained from bottom left corner
- Chained from bottom right corner
- Chained from top left corner
- Chained from top right corner
- Single Point from bottom left corner
- Single Point from bottom right corner
- Single Point from top left corner
- Single Point from top right corner
Output to specified layer
Switch this option on if you want the waste planner output to be created in a layer other than the current layer.
Output block mode
Use these options to choose how the waste identifiers will be grouped:
- Directly into layer - no grouping is performed
- Into single block - all waste identifiers will be grouped in a single named block
- Block for each waste area type - one block each will be created for Back edge, Internals and Sides
- Block for each waste area - one block each will be created for Back edge, Internal of carton, Internal of sheet, Left and Right