Will allow you to change the properties of a rubber block.
The Edit Bar controls will display the following options when the tool starts:
Rubber Edit - The current tool.
Multi-up Replicate - Same name block replication (here wrongly called multi-up replication on the Edit Bar) can be enabled, i.e. do this only for the block you pick or all blocks with the same name as the one you pick. The Replicate option is modal, i.e other Rubber Edit tools will have the replication option set as it was used last time by any tool in this group.
Retain split end shapes - If you change the rubber thickness on a block which has been split, the split ends are removed or changed on the edited section. Switching this option on causes the angled ends to be retained.
To use: Pick the block to edit and the Rubber Attributes Form will be displayed. Set new values and click OK to apply.
Tools described in detail: