Open navigation

Male Upper Rubber

This is a sub-page from the Blanker Wizard form.

Blanker - Male Upper Rubber


Switch this option on if rubber geometry is to be created for the upper parts.

Into layer

The rubber geometry can be transferred to another layer by checking this option. If this option is not checked the geometry will be added to the current layer.

Layer name

From the pulldown list choose the layer or enter the layer name required.


This option determines if the rubber will be created in a sub-block.

Block name

Enter the required block name for the rubber geometry.


Enter the distance to offset the rubber profile in from the upper part.


From the palette pulldown choose the palette for the rubber geometry.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.

You may like to read -